Duet and Simplify3D setup for dual extrusion.

Problems related to the heart of your Printer?

PlasticMetal
Posts: 33
Joined: Mon Nov 19, 2018 12:21 am
Printer Variant: RailCore II 300ZL
Has thanked: 2 times
Been thanked: 5 times

Re: Duet and Simplify3D setup for dual extrusion.

Post by PlasticMetal » Sun Jan 27, 2019 11:17 pm

Suggestion to check wiring pairs deleted. Looks like we were posting at almost the same time.




Topic author
Emparus
Posts: 71
Joined: Tue Nov 06, 2018 9:11 pm
Printer Variant: Still Building
Been thanked: 2 times

Post by Emparus » Wed Jan 30, 2019 12:29 pm

Yes you should always check the wiring first. All other steppers I had were correctly wired but that was just luck. There is apparently no consensus on the colors used.

Post Reply